-40%
(pack) Piston-Rod Sealing U-ring K36 NBR ID 38mm-140mm (choose dimensions)

(pack) Piston-Rod Sealing U-ring K36 NBR ID 38mm-140mm (choose dimensions)

$ 1.34

Availability: 3200 in stock
  • Brand: Unbranded/Generic
  • Refund will be given as: Money Back
  • Return shipping will be paid by: Buyer
  • Item must be returned within: 30 Days
  • Condition: New
  • All returns accepted: Returns Accepted
  • MPN: Does Not Apply
  • Restocking Fee: No

    Description

    K36 is a single acting piston - rod seal which consists of reinforced cotton fabric and nitrile rubber vulcanized together forming an integral sealing element.
    PRODUCT ADVANTAGES
    • Functions even with poor surfaces
    • Reinforced cotton fabric base prevents the seal from extrusion
    • Both rod and piston application
    • Good sealing at low pressures
    APPLICATION
    Low to medium duty hydraulic cylinders , mobile hydraulics and presses.
    MATERIAL
    CODE
    NBR
    80 SHORE A
    NB
    8801
    COTTON FABRIC NBR
    NB
    8004
    OPERATING CONDITIONS
    MEDIA
    Mineral oils (DIN 51524)
    HFA ve HFB
    HFC
    TEMPERATURE
    -30°C +105°C
    +5°C +60°C
    -30°C +60°C
    PRESSURE
    ≤250 Bar
    ≤250 Bar
    ≤250 Bar
    SPEED
    ≤0.5 m/sn
    ≤0.5 m/sn
    ≤0.5 m/sn
    Note: The above data are maximum values and cannot be used at the same time.
    SURFACE ROUGHNESS
    Ra
    Rmax
    Sliding Surface ØD-Ød
    ≤0.4 μm
    ≤3.2 μm
    Groove Base Ødp - ØDb
    ≤1.8 μm
    ≤6.3 μm
    Groove Flanks B
    ≤3.2 μm
    ≤16 μm
    Note: It is recommended to have 50% to 90% of the working surface material contact area value.
    INSTALLATION
    K36 is to be assembled into open grooves. It is very important that the assembly tools must be of soft material and have no sharp edges. Before installation the sealing element must be oiled with system oil.
    NOTES
    The permissible sealing gap values of K36 piston - rod seal is given in the below table.
    PERMISSIBLE SEALING GAP
    Pressure(Bar)
    S (mm)
    150
    0.2
    250
    0.1
    Note: The largest sealing gap value occurring on the non-pressurized side of the seal does have a vital importance for the function of the seal and in this respect it is quite important to use the S value lower than the above indicated numbers.